Search results

I have a new Wookong system that I installed and setup and it flies nice. I use 5.20 firmware as I believe its truly the last reliable firmware. It flies very smooth and stable in GPS, ATTI and manual modes. I have been reading and researching how to properly setup the failsafe correctly. I...

Is anyone using a Wookong or A2 with the graupner PPM signal? I am using a MX20 and have one small question that is baffling me. I have a new install with Wookong and I am testing the copters response controls with the copter weighed down by sand bags with just a little bit of slack so I can...

I am trying to calibrate the compass with WooKong and I having issues trying to get it to go into calibration mode. I read a bunch of threads and seem to get conflicting info. Right now my control switch is setup like this GPS Manual ATTI I start out the switch in GPS and then switch to...

I have a brand new Wookong M that I am just about finished with the installation but there's one thing that I can't figure out. The software and IOSD are reading my 6S battery fully charged (25.1 volts) as 17.9 volts. When I go try to recalibrate it, the voltage doesn't change regardless if I...

This is my first DJI install, and I have a rather simple question. I have everything wired up, and communicating through my laptop. I installed 5.20 firmware with 1.36 software and I calibrated my TX. I have registered with the site as well. However I don't see any selection to see the advanced...