Search results

From my quick calculations I did from some data I captured, it appears to be 60Hz data. I can't say that with 100% certainty. Later today I'll try to do a more exact test, unless you figure it out before and post what you find out.

Anybody have any suggestions on how to provide power to my LEDs with a 6S battery? LEDs have a 12V input, and I know I can go with a BEC for this, but I'm thinking cheaper and lighter, and someone told me that I can easily get a 12V DC output transistor from Home Depot or someplace like that...

You can download the iOSD Assistant Software from the DJI product page: http://www.dji-innovations.com/download/iosd-mark-ii-downloads/

No, that isn't the case. The VDL accepts standard definition video (I used it on one MR with iOSD, and one without), and the iOSD also outputs standard definition video (to allow you to hook up to other VDL). However, the iOSD comes with a special 6-pin wire that goes between the iOSD and the...

Ni job HazardPro! My vibration kit arrives next week. Can't wait to install it and see how it helps my S800. Mitsaras, I get a flicker also. I'm using the 16mm on the 5R with the DJI VTx and I get flicker once in a while. I just figured it was my Tx/Rx connection, not the camera.

Yep, good article. The only problem is that the author is glossing over IR and what a large disparity of IR will lead to, or if one cell is dying/dead. If I come across the article that addresses that, I'll post it.

Well, yes and no. You are correct that the balance board and the charger are differentiating between cell #1, and cell #2, etc. However, all of the cell #1's are connected in parallel, so the charger is seeing one conglomerate cell #1 and the "average" of all cells #1. So if cell #1 of...

RTRyder, couldn't you have done the VTx antenna on the bottom? That's what I'm doing with mine (though it's a DJI VTx); it's hands downward for nothing to obstruct path.