Search results

Shredded mine quite easily - but the tree remained undamaged o_O

And do a Tx stick calibration.

One of my SkyJibX4TiQR has a WKM controller and the other an A2. Both function fine. But would not consider fitting a low cost budget controller.

Are all your TX trims set in the centre ?

My view is go with the Inspire but a 2 man crew because its safer and the camera person can concentrate on getting the best image.

Futaba have an update that incorporates Tx voice information. I have 2 Tx's. One on version 3 and one on version 5. I have read that from version 5 upwards you can only use genuine Futaba receivers and ask if anyone has any experience about this? Second question is will I lose all my current...

This would not hurt a woman pilot !

The press, public and professionals all need to first appreciate a DRONE is any Unmanned Aerial Vehicle that is remotely controlled and within this Drone category there are aeroplanes, helicopters and multirotor aircraft. And it important to distinguish which was the offending Drone Type ? There...

Much appreciated. I think I reached the same result after finding out the small circuit board with the potentiometer is a servo throw adjuster which works with spectrum analogue servos. I just found it impossible for anyone - even Aeronavics to explain what the circuit board with the...

PANDAS model flying club are hosting a multirotor fly in at Pontefract Park, West Yorkshire on June 4th 2016. Start time 10am, finish approx 4:00pm. This is being run in conjunction with the clubs annual fun fly event. Besides sport multirotor flying from the heli patch, we will have a...

Still no luck with making the servo rotate any further. This spectrum servo is anyalog so unable to make any changes to the actual servo. So I have purchased a digital servo and servo programmer which should arrive next week. This should let me set up the servo end points to a set command from...

Yes I like your idea. Might give this a try at the weekend. Thanks for this.

I have already bypassed the Aeronavics landing gear control board because I could not find out what it actually did. End points still will not function. Do you think the control board is a servo pulse spreader. To stretch the servo pulse to make the servo move more or less for fine...

Original Spectrum landing gear servo became faulty. This servo A7000 is discontinued. So replaced it with a spectrum A7040. However the legs will not raise to the same height any longer ! Ok simple solution use the servo endpoints to increase servo rotation. Not that simple because I am...

Mine would not fit in the hole :p

I fly A2 but cable up to lap top and don't use Bluetooth connections.

I fly a SkyJib x4 Ti QR as a 2 person set up. Both transmitters are Futaba 2.4 ghz.

I see there are merits in both. I might therefore make the changes and have a play to see what it feels like. Thanks oldman and fpmurphy.

It depends what you do. If your a single aerial operator then wearing goggles is a no go. This is because you have no visual unaided sight of your aircraft. If your a duel operator then the camera person could wear goggles that may allow them to concentrate on the shot. If its for fun then...

This sounds logical and is how my set up works. My reason for asking was due to this other SUAS set up which I had a go with where the camera/gimbal was very different. Thanks for your advice.