Search results

You are doing the right thing. To make a great living at it you'll need to be doing it full-time, be ready to go at a moments notice and have no debt. Try to minimise all outgoings as much as you can and really take advantage of the profits to be made. Hope that helps! :nevreness:

Welcome to the forum mate! :nevreness:

Hey mate, There's a great DJI video on it somewhere. You basically need to work out how to scale the data so it appears in a readable way. And learn what all the units are! Look for DJI iOSD data interpretation or something like that.

It's thanks to this forum and it's support that I got flying in the first place. I have never been to a model shop and have not until recently known anyone else who flies RC. The resources on this forum have turned my hobby into a profession that I make a damn good living from. Thank you Bart...

I'm not sure how to react?! No more aerial media production but more time on the forum. Nooooo.....yaaaayyyy!? Glad you shared this with us nonetheless. We like it personal. :nevreness:

Awesome! :nevreness:

Hi Alan, welcome to the forum! So, where to begin. Learning how to program the DX7 will be you first hurdle. Without going into too much detail, you will essentially need to adjust the D/R or servo travel to adjust the various settings. To do this, connect the NAZA to the assistant program...

Yeah, it does seem like an ESC issue. Hard to tell which one though...

Great video! Welcome to the forum! :nevreness:

Brilliant! Awesome video mate! :nevreness:

Cool. You'll be all good then. :nevreness:

Good luck. Let us know how it goes. :nevreness:

Easy, the 4.5 is 4.5°. You have increased the angle of the props thus increasing the amount of lift they have per rotation and their sensitivity in reaction. You could probably make them work by lowering the gains quite a bit but you might as well stay with the props that work. What lipos are...

I personally use ImmersionRC 5.8GHz stuff. It just works and the range is great. I'd recommend the 600mw tx. I once got it to 2km on my F550! Your receiver/antenna is one of the most important parts! I use a diversity monitor with patch antennas on. The patch antennas make the signal...

Ah, is this the part where you tell us you bought a really old Zenmuse maybe? I think they stopped making those V1 boards along time ago, like 18 months. If you bought it new then I would still explore camera settings.

It does once it's in failsafe, but you need to enter frailsafe correctly, if that makes sense. If you set zero throttle, when the receiver enters failsafe the drone will drop out of the sky. It takes three seconds for the FC to enter failsafe.

...and set the HDMI out to 720p. :nevreness:

Hey mate, I assume the U channel on the NAZA is connected to AUX3 correctly? Are you adjusting the servo travel whilst connected to the assistant program and watching the little bar move? Is AUX3 setup on the DX8 with the MIX/HOLD switch? I would use the three position switch to control the...

Hey mate, Nope, not normal. It is likely a GH2 setting. Could be HDMI-out or PAL type thing.

Throttle should be set to 50% (technically above 10% but better safe than sorry :nevreness:). You can test on the assistant program to see if you have it setup correctly. Turn off your controller (transmitter) whilst connected to the program and it should enter failsafe mode.