Search results

Typical DJI, R&D non existent, spend $3,000.00, and now wait another week to fly. Priceless!

You get the quality you pay for, cheap motors will cost you more in the long run.

What does the motor log look like when your hovering in gps mode?

That's normal. Most likely your issue is with the frame, motors have to all line up perfectly level. Not even a 1/2 degree in any direction.

People, please stop extending ESC to battery wires. Your only supposed to extend ESC to motor wires. Esc's come with what the manufacturer has determined is the max safe length. Shorter is fine, just don't extend longer then stock. http://www.rcgroups.com/forums/showpost.php?p=4833040&postcount=5

I can't imagine the vibrations with those chunks of aluminum prop adapters.

--

They replaced it with this one:https://www.dimensionengineering.com/products/smartbec Here's the original one for less money:http://www.radicalrc.com/category/BEC-Voltage-Regulators-32

I ended up getting the dimension engineering 6v bec to run my Strobons on there own after seeing a 1/2 volt drop on my telemetry log files with it plugged into the receiver powered by the SuperX every time they flash while testing them. Figure it was not a good thing to have voltage spikes on...

If your starting from zero, figure a $1000 and up.

Then you need to fly it when there's absolutely no wind to get a baseline.

Both, had the 25's first, now running 35's.

Castle multirotor ESC's no issues with the KDE 515's, 53 hrs. Flt time with the superX.

Motor alignment issues. need to be within 5% in hover.

Post up a log file.

I did not do a compass or stick calibration when I first hooked everything up. As per the manual, I'm using futaba setup instructions with a Taranis connected via S-bus. I also get GPS lock through a solid concrete roof!

https://www.youtube.com/watch?annotation_id=annotation_2477775871&feature=iv&src_vid=PgMv2ucuRa0&v=YuS_gmN_7mQ

http://fpvlab.com/forums/showthread.php?8921-Official-Connector-Thread

Try lowering the height gain if your running it at 1.2:)