Search results

as long as it isn't VBB i am ok with it.

got a link that works for finding this. navigating the ys site is tedious, at best.

or get a real buttload of marshmallow cream<G>

not until the first of feb. am out of country on another type job until then.

the input and output voltage bus on most every rx is a direct connection, whatever you put in is what it puts out through the red and black/brown wires. the signal wire, white/yellow, will be a moderated voltage for servo control.

stick calibration on throttle may be off a bit. in either of those modes, throttle stick commands, centered hover, above center climb, below center descend. the further from center the quicker the climb/descend rate. make sure that the assistant shows the throttle in center when you have the...

anybody using the zero GCS software on a win 8 pc? working ok? glitchs? mine works good on win 7, but it is getting close to time to move to 8.01 or whatever it is now. and still wanting a GCS for my winphone 8.

i followed the installation guide. in the pc version GCS located under the settings tab/button. i have seen the android version GCS, and it also has the install guide, but i have no android of my own, so i have not tried to use that one. the install guide is good to use, as it will tell you...

some versions of the naza firmware did/do have the failsafe, automatically climb to 20-30 meters then return home, so you see the motors speed up as you described. zero uav does not do this. i fly 12z futaba set up failsafe as manual instructs for the ys unit. then set the FS options for the tx...

just a wild guess here, but, when you did this, was the copter in the same place as you initialized it, when you activated the FS/ret home function? as in, it has to be away from home to know it has to return home. if it was still sitting where you set as home, then just shutting the motors...

got to do a coupla minutes/laps on one of the new CY Stingrays at the Abilene TX heli fly in over the weekend. nice quad. different theory of operation from what the current norm is. One motor driving all 4 props with full collective control on all 4. not your same old naza flight. seriously...

i have 2 ys x4 systems, one wifi and one navi. i found both of them easier to set up than the naza/gps i have, or the FY 91 nav i used before. found the gcs program easier to use/understand than the assistant from DJI.(win 7 pro on both my desktop and laptop) my only real complaint with the zero...

i don't use a gimbal. yeah the same 13 x 6.5 that you linked to.

can't say about the frame or the gimbal, as have never had hands on either. the other stuff is same as i use, and has been working well.

rct motor i use that one you linked to as well as the 650 kv version. the 650 works well with 4s. they perform well. Y-6 platforms 650mm and 800mm

yeah, but man, this desktop unit sure gets heavy strapped to my back out in the field.

i am just waiting for them to adapt the PC gcs for the Winphone. seems like that should be an easy step to take.

wacky failsafe stuff is something that happens with other non factory rx when used with FASST systems.not to surprising it happens with the one in the A2.

as always, the item itself is not bad or good, evil or righteous. it is the folks that decide to use it that are bad or good, evil or righteous.

not the first buy a few years, and one site, RR, suggest this is the 3rd heli related death this year. just waiting for some reporter to realize that that heli wasn't a "toy", it is a "drone".