Search results

cool, SleepyC does a bit of that..... less fpv and more videoing

showing a little roll drift

you can't run multiple bec through wookong like your showing,, just noticed. it is going to backfeed into the dji pmu.... you would bypass the rx being powered by the bec in the pic and take those power wires straight to the servo, only use the signal from the rx to switch the servo open/closed...

agreed....

theres a pile of 333 exemptions coming down the pipeline that's gonna change all that. case by case consideration.... supposedly

vortex, are you using a monitor? does it have various pal and ntsc offerings to choose from? might flip through all of them to see if one is working better

so in looking all this over i'm realizing i'm open to lvc by t-motor esc. Everybody using these on a multi will want to change the setting lipo to nimh... everything else would remain the same unless otherwise told to change something due to the motor setting timing higher can make more to alot...

That and the fact you have a shortcut. Done like i posted works killer to monitor current and voltage. because the packs wind up being parralel the voltage from both is always shown, only thing that's goofy about it is it is showing you half of the actual current cause it's one pack..... double...

That's him, he will respond to you here today, i'll make sure

heres the immersion before i screwed up the firmwrae

you had asked in a post and this was my response in a picture, you had takin it wrong. i've had three of them setup like this with hundreds of hours logged. no problem what so ever. you can't pass by and pass through the current sensor, it'll never move ..... the way you drew it there isn't...

yea, definately only run it on one battery lead,,,,

with the phobotic board i'm told it'll carry dslr with these motors on up to an epic with larger motors. talk to andrew and get an official blessing.

the 3.6 sounds on par, next i'd look at prop balance. What are they?

a high amp reading can be motor failing/bad bearing bad prop balance bad motor alignment cold solder joint if it's new never crashed my money would be on prop balance and motor alignmet, if a prop has ever broke my attention swings towards the bearing going out. Try reving it up ont he bench...

looks like it.... the current sensor goes in and goes out, not passed by also right?

They certainly aint out celebrating record profits like the gas companies are..... ridiculous

it could be alot of things, get ahold of patrick to see if he can get ya sorted.

the g2 3 axis with a gh4, decent glass and all the goodies for two man including a 5 amp hour 4s is 5 lbs. We couldn't get an idd200 to work mechanicaly on any board,,, that v drive things pretty lame