Recent content by ShackFlyer

Slows GPS aquisition & home point recording to the point where you can wait forever depending on site. Dunno on G2, never used one, all I know about them is nobody rates them as they are forever resetting in even gentle flight. To the point where most people think they are flawed. Sent from my...

The BT module supposedly powers down when the motors are unlocked & powered up for take off. So it's not exactly useless. Also it's easy enough to plug & unplug if you use it on the G3 gimbal. Sent from my SM-G920F using Tapatalk

In principle FW changes will not affect how BT affects the FC, as it is interference with GPS Rf signal reception that it caused. Sent from my SM-G920F using Tapatalk

Gremsy H3 will be worth your attention also. Soon to be released Sent from my SM-G920F using Tapatalk

You are wasting your own time IMHO get a Zen. I have both Zen & G3-GH, chalk & cheese. I wasted months trying to tune the G3-GH, it's a flawed design.

Mine & a colleagues are running it fine. His is an early one, mine is less that 4wks old.

You could try putting it in a chest freezer for 20 mins or so then powering it up. I did that with a Futaba T10j to dignose a faulty Rf board

That's bonkers manufacturing different versions like that for different markets...oh well at least we get all the bits in the UK we need, even if we take some out :rolleyes: I have a Spektrum DX6i but hate the programming. Comparing the 14SG & 10J, the Tx programming I find easier in the 10J...

T8J is still available in UK but not much cheaper than 10J. Also in the UK the 10J is on offer with 2x Rx's which wipes out the price difference as the Rx's are £50

They don't over here in UK as well, but you don't need any extra parts, you can just convert with a similar throttle gimbal plate removal. That's how I did mine

As an aside, a colleague has had 2x genuine Spektrum Rx's burn out on his Z15-GH4 before moving to a T8J. He has had no issues since. Also I personally had a cold temp issue with my 10J where it showed it was transmitting Rf, but it wasn't as Rx had no signal. Ripmax replaced the Rf board under...

You can convert them by just taking the plate off the back of the throttle gimbal inside, but we use the Std NON sprung centred throttle as we can 'set' the tilt & leave it, so it moves in relation to stick position. This depends on the gimbal controller that you use. On the 10J we have if you...

Personally a T10J cos I had one, but a T8J is cheaper if you are having to buy one. Both have S.Bus Rx included IIRC You will find a T6J on E Bay etc cheaper. Same protocol & cheaper

I had considered something like that, however this is brand new out of the box, & my supplier said the last one they had that did this was eventually solved by a replacement HDMI board. This is the reason why they are just swapping the whole thing as faulty rather than doing warranty repairs...

TBA if the next one arrives & does the same I will have to reconsider whether to go with something different