My Roll gets out of horizon when I pan or rotate the aircraft. About 8 degrees, then slowly it goes back into good horizon.
This is the "left over error", right?
Changing the roll integral gain doesn't help at all, I cannot see a difference if I put it to 100 or 500.
My gains:
tilt position 170...
I have problems with my pan servo. I am not able to start and stop panning smoothly.
Which pan servos do you use?
I got the hyperion ds16-fcd on my av130.
I solved my jitter problem! On the 2nd hole from bottom it's working better for me, even if I have to go out of roll balance to be able to tilt 90 degrees down. The roll can handle the out-of-balance much better than the tilt.
Anyway, that works o.k. now, but I figured out a new problem: if I...
Which camera do you use, PondMedic? Maybe it's relevant how good you could level your camera in the AV130.
My problem is that I have to put the tray in the lowest position to be able to operate the CX730 and then when I tilt it the camera is front heavy, the tilt servo has to fight against it...
still jittering
The camera tray is already in the lowest position. With the Sony CX 730 I have to be there otherwise I couldn't look 90 degrees down.
A little video of where I am now (the flying video is stabilized by CX 730), still jittering…: http://youtu.be/Pi93EIrZwvQ
Any ideas what I...
I am very very happy with the results now (1.2.2 / av 130 / felt washer on tilt). But there is still a little jittering when the camera is tilted down. I balanced the camera position as good as I could and in horizontal position there is no
jittering at all. But when I tilt down, the camera gets...
Thank you very much for the hint how I can set it manually. Sometimes you can't see the wood for the trees.
With roll it works very good now with manual tuning.
With tilt I do auto tuning and I'm fine now and only have to do fine tuning and can't wait to do a test flight!
Thanks a lot!
Andy
Soaringclauz:
I would really like to do manual tuning! With my software 2.1 it's not possible because there is no button like this. In older versions there is a button but it's not working neither... No reaction of the servos when I change the values.
Does anyone manual tuning with firmware...