Recent content by daveleigh

  1. D

    Naza X-Y-Z Setup

    Hi Thanks Blusnapper for the reply ,I throught that was the case, much appreciated Dave
  2. D

    Naza X-Y-Z Setup

    Hi All just a quick one setting up my new GPS I'm a bit confused on the XYZ when they say positive and negative do they mean you put + in front of the CM figure if the gps sticks up or a - in front of the CM figure or just the CM figure .mine sticks up 11CM from the Nasa unit in the Z box I...
  3. D

    Esc set up help

    Hi Airconrod, thanks for the info , my program card reader manual is Chinese useless Thanks again Dave
  4. D

    Esc set up help

    Hi can any one help me with the set up below I'm not sure which to set!!!! My setup is 450 flamewheel Hobbywing 20amp Skywalker esc sunny sky 980 kv motors Naza Brake Off or On Battery type Li-ion / Li-poly NiMH / NiC Cut off mode Soft-Cut Cut-Off Cut off threshold...
  5. D

    Naza throttle startup speed

    Hi Kloner, this is embarrassing ! I did'nt know you had to!!!! I just did what the assistant said and to be honest I'M not sure how to ! any help would be appresheated thanks Dave
  6. D

    Naza throttle startup speed

    Hi Kloner, thanks for the intrest ,it all came as a kit , sunny sky motors KV980. Hobbywing skywalker 20amp esc's ,I got the Naza separatly, the throttle calibrates cleanly in the assistant window as far as I can see, trims 0 I tried resetting calibration with the throttle Half stick but still...
  7. D

    Naza throttle startup speed

    Hi Tahoe thanks for the reply , I'M on 10 x 4.5 with Sunny sky KV 980 motors. i've got some 9050 3 blades to try ,I will give them a go thanks again Dave
  8. D

    Naza throttle startup speed

    Hi can any one tell me if you can control the Combination Stick Commands moter start up speed? mine seems to be a bit fast it will almost lift off! F450 Flame weel thanks Dave
  9. D

    Naza throttle setup ?

    Hi Thanks Tahoe ,I just needed to know if it had to be set on the TX much obliged Dave
  10. D

    Naza throttle setup ?

    Hi noobe here ,can someone tell me if I have to setup the throttle fail-safe on my futaba transmitter? or will the fail-safe on the Naza do it's own thing I have it setup to go to fail-safe when I switch off the tx OK but I don't know about the TXs own fail-safe thanks Dave 450 Flame wheel
  11. D

    Hi from Dave Leigh Chatham in kent .

    Hi Ross ,sorry about the name thing ! I have an Alph jet like that ,it's been repaired more times than the M25 still fly's, Chatham pocket? never heard of it ,I'm in a place called Walderslade , between Chatham and Maidstone , a lot of clubs will not reconise FPV they say it's too dangerous ...
  12. D

    Hi from Dave Leigh Chatham in kent .

    Hi ,Dave thanks for the welcome , i haven't flown the easystar yet ,I will fly it with no gear first , I 've got Fatshark dominator 5.8 vid tx ,Gopro ,+ Pixim Sea wolf 690 HTV ,got to chose which to go with! But I think the way forward is Quad ! My club dosn't like the idear of FPV ,so cannot...
  13. D

    Hi from Dave Leigh Chatham in kent .

    Hi I have been flying rc planes for some time now , and have a passion for FPV, just built an easystar FPV ,and ordered an DJI f450 with a naza .first time into quad's! so may need some help!!!! from you guy's thanks. Dave
Top