Yeah, the windings are enamel coated and some motors extend the winding into the there wires. Max does this so when you cut the soldered tip off to shorten them, you're left with the enamel problem to deal with.
Still having my doubts about the enamel coated wires after I cut them shorter. Saying that, I cut the one that works just to see if that stopped it working. Used the same technique to de-enamel as the others (heated aspirin outside followed by flux) and it still worked like before. the others...
Haha, yes Im flicking between batteries and using a 2200 to check. I know I programmed them all via the transmitter and menu 6 I chose option 4 so the low voltage was turned off.
3 of them start to stall at 70% (after a while getting going) then the power drops and intermittetly cuts out on the way down. Only with 3 of them. One is strong all the way up and down.
Yeah, Ive connected directly to throttle on TX...same prob. Ive tried calibrating every option I can think of re the escs. I can't flash or update because I believe I need two extra pieces of hardware to get the firmware on the esc.
Im pulling my hair out. Never had such difficulty with a build in my life. Ive stripped the enamel from the motor wires, resoldered to esc and removed NAZE from equation. Even removed the PDBoard and hooked up directly to 3 different batteries. Exactly the same. EXACTLY THE SAME. Crazy what Im...
LOL, well I think I may have figured it out! The motor wires are enamelled copper and when you buy then they have tinned ends, however when you cut them you're left with a joint that doesn't like to solder. There is a chance that the one that works perfectly has a good ESC-Motor joint and the...
Hi guys. So I lost my TBS disco as RTH didn't work and fpv signal dropped. I presume battery fell out. Nightmare.
Anyway, been building a 250 racer instead.
I have Simon Series 12a ESCs with Emax motors 1804 2480KV and only one works. 3 of them stutter the motors and when finally spin up...
Ive built a TBS Discovery from scratch. I printed pics from the plates of the disco and sized them up in the printer % till the holes fitted the DJI legs then I cut the plates out of PCB board. I also made the Tarot 2-D a front facing gimbal with polymorph pellets that melt at 60degs and harden...
Ive upgraded my 9X to the frisky DJT and D8R- ii Plus and Im running a NAZA Lite with M firmware flash.
Ive calibrated the compass, calibrated the Flight C, calibrated the sticks and the thing is flying like its drunk!
It was perfect before the 'upgrade'. Anyone using similar setup?
Thanks Rotorfreek. Hey I just got one of those cell checkers you recommended. Im currently using the balance tap from lipo to power FPV. Any ideas how to use cell checker while also being able to power fpv? Does it have a 'through' power out or is it possible to split the balance tap?