texasdronedude
Member
Hi everyone,
I am stumped and could use someone's advice. Here is the scenario:
Gear:
DJI Zenmuse BMPCC Gimbal (new)
BMPC Camera (new)
DJI AVL58 TX (new)
Flysight Black Mamba TX5820 V2 (new)
Flysight Black Pearl RC801 (used but perfect working condition)
Need to run the "AV" output of the BMPCC gimbal to a TX to send the camera picture to the diversity RX of the Black Pearl monitor for the gimbal operator.
Both TX's (avl58 & black mamba) work fine. I know this because when I connect my video feed from my pilot fpv camera which runs through my MarkII iOSD the picture is rock solid to 300 meters. The Black Pearl monitors are set to "NTSC".
When I connect the "G7" (video output) port from the Zenmuse BMPCC gimbal's "GCU" (and 12v power via additional XT60 connection) to either TX (avl58 or black mamba) the picture from the camera to the Black Pearl RX is black and white and rolls vertically constantly.
Anybody seen this before?
Thank you!
//rob engle
I am stumped and could use someone's advice. Here is the scenario:
Gear:
DJI Zenmuse BMPCC Gimbal (new)
BMPC Camera (new)
DJI AVL58 TX (new)
Flysight Black Mamba TX5820 V2 (new)
Flysight Black Pearl RC801 (used but perfect working condition)
Need to run the "AV" output of the BMPCC gimbal to a TX to send the camera picture to the diversity RX of the Black Pearl monitor for the gimbal operator.
Both TX's (avl58 & black mamba) work fine. I know this because when I connect my video feed from my pilot fpv camera which runs through my MarkII iOSD the picture is rock solid to 300 meters. The Black Pearl monitors are set to "NTSC".
When I connect the "G7" (video output) port from the Zenmuse BMPCC gimbal's "GCU" (and 12v power via additional XT60 connection) to either TX (avl58 or black mamba) the picture from the camera to the Black Pearl RX is black and white and rolls vertically constantly.
Anybody seen this before?
Thank you!
//rob engle