rotorvista
Member
Can anyone please tell me if the POI and Go home are working on the wookong m 5.22 firmware as I cannot get them to work???
I'm using the 2.0 assistant software.
I've got the IOC assigned to a 3 position switch and OFF, POI and HOME LOCK turn blue as they should in the assistant software and HOME LOCK works but not POI.
I have the GO HOME assigned to a 2 position switch and it turns blue but does not activate the fail safe and does not work.
I'm using a DS16 tx. the DS16 fail safe works fine when i turn it off.
also on the TOOLS page in the 2.0 assistant software there are no parameters how do I install them please?
and i'm getting green flashing led lights instead of yellow for low voltage protection?
any help with this will be much appreciated
I'm using the 2.0 assistant software.
I've got the IOC assigned to a 3 position switch and OFF, POI and HOME LOCK turn blue as they should in the assistant software and HOME LOCK works but not POI.
I have the GO HOME assigned to a 2 position switch and it turns blue but does not activate the fail safe and does not work.
I'm using a DS16 tx. the DS16 fail safe works fine when i turn it off.
also on the TOOLS page in the 2.0 assistant software there are no parameters how do I install them please?
and i'm getting green flashing led lights instead of yellow for low voltage protection?
any help with this will be much appreciated
Last edited by a moderator: