Wiring Schema G-Lock BLD 3 axis

[Droider]

So here is the wiring schema for the Carvec G-LOCK and BLD drivers for a 3 axis set up.

More to come for other set ups

PDF download
View attachment 16622

 

[tombrown1]

Wait a sec. I thought g lock was supposed to do 3 axis from 1 radian. What am I missing here?

Also, have you had any success with it?

 

[Droider]

The G-LOCK converted radian `DOES' do three axis servos. The schema is for the brushless conversion.

Dave

 

[jes1111]

I think tombrown's confusion is in the diagram - it shows 1 G-Lock Radian (bottom left) and 2 BLD (BrushLess Driver) modules (top left and bottom right). Each BLD can drive up to two motors, hence the two modules. Each G-Lock Radian can measure/control up to three axes.

 

[tombrown1]

Ahhh... Thank you! I need to read up some more on this. I would love to get off of alexmos.

 

[Droider]

I think tombrown's confusion is in the diagram - it shows 1 G-Lock Radian (bottom left) and 2 BLD (BrushLess Driver) modules (top left and bottom right). Each BLD can drive up to two motors, hence the two modules. Each G-Lock Radian can measure/control up to three axes.

Nice one jes. I drew it how I was installing it on the gimbal. so Radain under camera tray, one BLD next to tilt motor and one up top as close to roll and pan as I could get it.

Guess it may have been better just drawn in a line.



Dave