when i tilt my hexa the motors stop running ??
- Thread starter john420
- Start date
OneStopRC
Dirty Little Hucker
Did you follow manufacturers recommendations for calibrating the esc if they need it? I did mention that but you failed to respond to my suggestion.
°~------------------------------------~°
Sent from my electronic telecommunications thingy using my fingers and this Tapatalk do jiggy.
°~------------------------------------~°
Sent from my electronic telecommunications thingy using my fingers and this Tapatalk do jiggy.
Last edited by a moderator:
15crewdawg
Member
When you roll it back to level does the stopped motor restart?
Hi, when everything on your system is set for level flight and you tilt your hexa the flight controller will try and re-level the hexa, so the motors on the high side will slow down (or stop at low throttle setting) and the motors on the low side will increase in speed, seems perfectly normal to me.
regards - bruce
regards - bruce
15crewdawg
Member
That what I was thinking too.
DucktileMedia
Drone Enthusiast
try putting smaller props on and see what happens.
Thank u guys for responding so when there is no prop and it tilt to one side 2 or 3 motor of my Hexa stops and when it is level they are all running smooth and that happens when the throttle is lower then 50% so I thought if the 3 motor stops in the air it will fall down would not u think so as u say it is normal does yours do the same thanks
OneStopRC
Dirty Little Hucker
Because this is NOT the correct way to do it.
I did the search for you, it is pretty easy to locate things on the internet using "GOOGLE".
Follow the instructions for setting up your ESC's here http://www.hobbyking.com/hobbyking/store/uploads/981522291X561242X33.pdf
If you require information on your product, you need to provide information too, we have no idea of what the ESC is that you have.
Page 4 shows you how to program your throttle range and also shows you how to program without a programming card.
Last edited by a moderator:
I got the T-motor 30a advance ESC http://www.multirotorforums.com/showthread.php?13604-when-i-tilt-my-hexa-the-motors-stop-running
i did those just connecting them one by one to throttle I put the throttle to 100 then connecting each ESc to Ch 3 and connecting the battery then reducing the throttle to 0 but instead the motor was started running when i reduced it to zero so it may not need the programming does Is the program card is necessary ?
i did those just connecting them one by one to throttle I put the throttle to 100 then connecting each ESc to Ch 3 and connecting the battery then reducing the throttle to 0 but instead the motor was started running when i reduced it to zero so it may not need the programming does Is the program card is necessary ?
Futaba 10c