voltage monitoring issue - blinking orange; best 2.4 GHz radio control for Naza

[andiwand]

Hi there,

I have two issues/questions.

1. If I connect a full battery to my Naza it starts blinking orange. So I turned on the Naza Assistant and switched of the voltage monitoring feature. But the Naza (the VU actually) keeps blinking orange. What is this? As far as I can see from the manual, blinking orange only indicates low voltage. I tried calibrating and even when I switch the monitoring off it persists. (I am quite unhappy with the feedback when writing something to the Naza, there is no sound or blinking indicating the success. I check by reading it out, but I don't really trust it. Do you have way to be really sure what has been written.)

2. I'm looking for a 2.4 GHz radio control for the Naza. For now I'm still using an old 35 MHz one. Do I understand the manual right, that I need two 3-position switches? One for GPS-Atti_Mode- Atti_Mode - Manual_Mode and one for Home_Lock - Course_Lock - Off. Or is there another way to handle all modes with only one 3-position switch and two 2-position switches. As far as I know the Turnigy 9X 9Ch has only one 3-position switch. Is that right?

Thx for your help,
Andy

 

[kloner]

it single blinks when atti is on, double blinks orange when voltage is getting low, flashes resd when it's landing. i'd turn it off and use a timer.

sometimes if a packs c rating is too low or the battery is damaged (high internal resistance), you'll see the double orange spark pretty fast

 

[andiwand]

Ah, thanks, you're right. It just shows that the Naza is in Atti Mode. I didn't see that before in the manual.

Thx, Andy