Simon Templar
Member
Just finished my F550/WKM build.
Installed the 64bit driver (windows7) and the Assistant software. However, when I attempt to open the Assistant software I get a message stating that 'a problem has caused the program to stop working correctly, Windows will close the program.... Etc'
Have reinstalled both the driver and the Assistant. No change.
I did install the Assistant a few days ago and it ran more or less as expected (without having a WKM connected at the time). Haven't mucked it since...until now.
Anyone else run into this before? Any ideas where to go from here?
....sT
Installed the 64bit driver (windows7) and the Assistant software. However, when I attempt to open the Assistant software I get a message stating that 'a problem has caused the program to stop working correctly, Windows will close the program.... Etc'
Have reinstalled both the driver and the Assistant. No change.
I did install the Assistant a few days ago and it ran more or less as expected (without having a WKM connected at the time). Haven't mucked it since...until now.
Anyone else run into this before? Any ideas where to go from here?
....sT