SamaraMedia
Active Member
Ok, I've converted my UAP1 hex from NAZA to Super X and now it's time to connect the OSD. I'm using a Pixim Seawolf for my pilot FPV camera which needs 12v. I'm running 6s for power and Immersion 5.8 vtx which outputs 5v so that is not going to help me with power to the Pixim camera. I guessing I need the buc converters Kloner mentions and run that off my PDB. Some of the wiring diagrams I seen whether it is on the XAircraft OSD manual, which from what I see doesn't address power to a fpv camera, just signal and ground while online I find I need to run just a power line from somewhere, ground to the camera looks to be coming off the OSD. Is that correct?
As far as cables going into the OSD I think all that was included in my purchase was one AV out cable, no 3.5 mic cable. Order them from XAircraft or source out from electronics store?
Thanks, John
As far as cables going into the OSD I think all that was included in my purchase was one AV out cable, no 3.5 mic cable. Order them from XAircraft or source out from electronics store?
Thanks, John