strong interference dji WKM

Pablo74

Member
hi all there 'ever take strong interference that are losing control of the WKM?
me and 'successful flying in the vicinity of a famous Italian television, and I honestly do not know what' happened .. : (
There 's never happened?
collagando the controller to the software and 'okay
 

Dewster

Member
It might be a problem with your radio receiver. What radio are you using? I flew my Hexa near power lines, radio towers etc while obtaining aerial photos. I didn't experience any problems from my Futuba diversity receiver. I am mindful of potential radio interference when I fly near other transmission stations. Were you able to land your craft?
 

Pablo74

Member
It might be a problem with your radio receiver. What radio are you using? I flew my Hexa near power lines, radio towers etc while obtaining aerial photos. I didn't experience any problems from my Futuba diversity receiver. I am mindful of potential radio interference when I fly near other transmission stations. Were you able to land your craft?

hi, thanks for reply,
radio futaba t8fg with rx sbus
the middle and 'landed a little damage to the camera mount sharply,
very strange that the camera has stopped recording before the crash, this does not explain it to me :(
 

Dewster

Member
hi, thanks for reply,
radio futaba t8fg with rx sbus
the middle and 'landed a little damage to the camera mount sharply,
very strange that the camera has stopped recording before the crash, this does not explain it to me :(

I have the same radio. I flew my craft near power lines, radar domes (not sure which direction they were facing, cell phone towers. Now I'm super close to these objects (except the power lines.... that was a photo shoot....). I haven't received any control issues or even twitching from my craft.

My Hexa recently crashed when a carbon fiber prop broke mid flight. I was recording video too, but due to the crash the video stopped recording on the memory card. The recorder didn't finalize the video so without special software I'm unable to recover it. I think it was the crash that caused your filming to stop.

Are you using a video transmitting on the same frequency? It could be that one of the towers caused interferrence. I imagine a strong enough signal would distrupt most radio communications.
 

Pablo74

Member
As with the video frequency 1.2 GHz low pass filter ... but not the first time I fly so, my concern that Dji is most likely subject to interference from other repeaters or wifii The video has been interrupted before the fall
 

Top