Cannot get my tilt control on h32d to work right with the DX8. I am going from x1 on NAZAv2 to the AUX3 - dial on the right top of the radio. Trouble is when you turn the dial it's either level or pointing straight down. Looks like it is only two positions. The Zenmuse assistant is not recognizing either. Any help - much appreciated!
Spektrum DX8 & H32D pitch control
- Thread starter azilk
- Start date
JoeBob
Elevation via Flatulation
Had the same issue with my DX9 - Easy to fix.
There is a separate assistant software for the gimbal:
View attachment 16160
http://www.dji.com/download/zenmuse-h3-2d-gimbal-downloads/
Install it; run it; it's mostly downloading the new driver.
Then go back to the Naza Assistant and calibrate the x1, which was gimbal tilt on the knob with my DX9:
View attachment 16161
AT least that worked for me. Since the Naza Asst software had gimbal calibrations, I thought I was done and didn't even know there was Zenmuse Asst software, too. BTW, you'll plug into the USB on the GBU to run the Zen Asst software.
There is a separate assistant software for the gimbal:
View attachment 16160
http://www.dji.com/download/zenmuse-h3-2d-gimbal-downloads/
Install it; run it; it's mostly downloading the new driver.
Then go back to the Naza Assistant and calibrate the x1, which was gimbal tilt on the knob with my DX9:
View attachment 16161
AT least that worked for me. Since the Naza Asst software had gimbal calibrations, I thought I was done and didn't even know there was Zenmuse Asst software, too. BTW, you'll plug into the USB on the GBU to run the Zen Asst software.
