setting up the Futaba 8ft from the octocopter

[diverdan]

Just got a 8fg super, and need to config for my ocotcopter . I have the Wookong M controller. Can anyone assist me on setting it up. It say i need aerobatic mode. Where is this in the menu?
Many thanks

Dan

 

[DaveM]

It just means to set it up as a Plane and not as a Heli, heli mode may intoduce some
unexpected mixes depending on settings.



Dave

 

[diverdan]

Thanks. for that simple reply..Is there any other setting i need to address, or shall i wait till i make my maiden flight!
Dan

 

[DaveM]

Just will need the usual for setting up a new TX.

Calibrate in assistant software, make sure all sliders are going in the correct direction

Setup failsafe, Assign a 3 Pos switch for ATT, GPS, and MAN

Perhaps assign knobs or sliders for X2 and X3 for remote gains

and eventually possibly a mix to a switch to simulate failsafe



Dave

 

[jetforce]

Here 3 point Norma/Atti/GPS video : http://www.youtube.com/watch?v=XYXC8eZiUcU

 

[diverdan]

thanks for that Lars.
Dan