scratch built 8 - 900 w / naza M V2 hex copter

[rubilac45]

I;m having lots of trouble with this F C , I can't eliminate the error # 29 message , for one . It;s telling me the sticks are

not centered . So while tethered it lifts off nose first all the time , and needs me to push elevator / cyclic forward

at least 25 % for it to level off . Second , I cannot get it to go into calibration mode , to calibrate the compass .

Does anyone have a solution ? Weight and balance is as close to center as possible for trims to fine tune , BUT ?????

Motors are wired correct , rotation is correct , calibration for IMU says " ready " but seems like it has an aft CG , which it

doesn't . Is any familiar these problems or know how to change center of stick , without putting both batteries in front ?

I'm beginning to lose it !!!!!!!!!!

 

[soler]

Can you post some picture of your set up and possibly screen shots from the naza assistant showing the sticks at mid point

 

[rubilac45]

scratch built hex copter

Can you post some picture of your set up and possibly screen shots from the naza assistant showing the sticks at mid point

I cannot edit , or post attachments etc . But after watching the great videos on this site , under product review tab , for Naza M V2 ,
I was able to center the sticks , and eliminate the error message , I can even get my hex copter into calibration mode .
So thanks , this a great site . I still have to dbl check all wires , motors , props , and ESC's for proper / uniform programming .

I'll be glad to send pics direct if you tell me how .

JJP
rubilac45@gmail.com

 

[soler]

I cannot edit , or post attachments etc . But after watching the great videos on this site , under product review tab , for Naza M V2 ,
I was able to center the sticks , and eliminate the error message , I can even get my hex copter into calibration mode .
So thanks , this a great site . I still have to dbl check all wires , motors , props , and ESC's for proper / uniform programming .

I'll be glad to send pics direct if you tell me how .

JJP
rubilac45@gmail.com

Good to know its working now,