XAircraft regarding the camera mount

[paktazh]

Hi guys I got a question regarding the camera mount with 2 servo and my question is should I connect the servo to in put or out put and do I have to make a connection for servo from (fc1212-s ) to receiver as will ?
thanks in advance

 

[Kilby]

The output from the 1212 will go to your two servos on the camera mount. This will allow the 1212 to stabilize your camera. If you want to set up a slider or switch on your radio to move the camera mount (tilt down for example) then you would have to run a servo wire from the channel you are using on your rx to the appropriate input on the 1212.

 

[paktazh]

Hi

Hi
I am using futaba receiver with 10 channel and
[h=1]Xaircraft 2 axis camera mount + 3 FREE servos[/h] so if I understand correctly I connect all 3 mount servos to the output of the 1212 and then from 1212 input I use a cable to connect it to the Futaba receiver .
thanks

 

[Bowley]

Don't forget to use a BEC.

 

[paktazh]

What is BEC?

 

[Bowley]

Battery elimination circuit.
It will provide sufficient power to run the gimbal servos. Connect it to the power distribution harness, you should have one spare connector. Connect the output into your receiver power port. I was advised to use a 5V 3A BEC I got a turnigy one for about £5.

 

[paktazh]

Thanks for your help
but is there any video tutorial for Futaba radio I got a 10 channel one
Thanks again