Firemedic501
New Member
Hey all -
I have a dodgy ZMH3(horizon tilted), so I thought I would replace it. I decided to install a Quanum Q3-3D gimbal instead of another expensive Zenmuse.
Apparently, part of the cost is instructions! Has anyone done this before, or am I blazing a trail. I have the gimbal, a bunch of different wire harnesses, leads, and no corresponding place to plug them in the P2. I'm not shy about cutting/soldering, but I was hoping for some directions. Did I just waste $150 saving money??
I have a dodgy ZMH3(horizon tilted), so I thought I would replace it. I decided to install a Quanum Q3-3D gimbal instead of another expensive Zenmuse.
Apparently, part of the cost is instructions! Has anyone done this before, or am I blazing a trail. I have the gimbal, a bunch of different wire harnesses, leads, and no corresponding place to plug them in the P2. I'm not shy about cutting/soldering, but I was hoping for some directions. Did I just waste $150 saving money??