Ppm not working in cleanflight

M

moraitis_george

New Member
Hey all,

I am building my very first drone and the first difficulties have started.
I have made the following wiring from spracingf3 to D4R-2 but I cannot make the channels move into cleanflight. My TX is Turnigy 9XR pro
I haven't set anything yet in cleanflight , except setting ppm mode.
The strange thing is that in cleanflight I can see the bars of channels centered in 1500 but all move +-1 digit continuously even if I don't move any stick on my TX.
Do you have any suggestions, because this thing will drive me crazy?
fcd583b88bc57a9467a2e65ea4c3541a.jpg


Sent from my SM-N910C using Tapatalk
 



M

moraitis_george

New Member
The solution was so simple. A stupid mistake.
I didn't assign on mix of TX what each channel should do (elevator, throttle etc). There have been almost a year since my last interaction with TX and yesterday as I was checking my old setups for swashplate helis, I remembered. Did it and everything works perfectly.
Problem solved. Thanks for your advices.

Sent from my SM-N910C using Tapatalk
 

You must log in or register to reply here.
Top