After building the quad and getting things connected. I connect the pixhawk to the MP and right under the disarm I get the "Failsafe" and on down I get the "No RC Receiver". I also get another message but it will not stay on long enough to read. And the is another message that starts out with "PX2V" something but it also does not stay long enough to write all the numbers down.
Pixhawk on X4 quad
- Thread starter Chalagi
- Start date
Old Man
Active Member
With the understanding you've got a lot of time and effort into the Pixhawk perhaps it might be better to obtain an Eagle Tree Vector and swap the Pixhawk out. The Vector is very easy to install and set up. The down sides are it does not have waypoint and autonomous capability, yet. You've had a lot of difficulty with the Pixhawk which is interfering with your enjoyment of the copters.
Very true about a lot of trouble but I have always been a really hard headed kind of guy. And I"m not one for letting something like this beat me down. Believe me I have had some really hard times with electronic equipment and vircuit boards of the pixhawk isn't much harder than those lololol. It's just me getting my head into it so to speak and I take a few breaks after getting stumped but I jump right back into the thick of things again.