Pixhawk motor test

[Chalagi]

When I go to do the motor test I click on the first test box and some times I get a "Denied by autopilot" and then sometimes the motors beep but do not spin up.

 

[JoeBob]

You have to engage the arming 'safety' switch before motor test will work.

And you really have to bump up the throttle percentage at the top of the screen. I had to jack mine all the way up to 30% to get the motors to spin in test mode.

Props off!
Or show us your stitches.

 

[Chalagi]

Thanks for the reply JoeBob

 

[Chalagi]

While I was in the pixhawk program I "Disabled" the motor spin at arming and then saved the file. Well I tested it to see if it would work and it still spins at arming. Any suggestions?

 

[dazzab]

While I was in the pixhawk program I "Disabled" the motor spin at arming and then saved the file. Well I tested it to see if it would work and it still spins at arming. Any suggestions?

Have you calibrated your ESCs and done the radio calibration in Mission Planner. Sounds like your endpoints are off.

 

[Chalagi]

Esc's and radio are calibrated in mission planner. I will check my end points tomorrow morning.