clausjepsen
Member
I wanted to charge my two new Hyperion 5000 mah 25c, so I connected the first to the paraboard with power cable and balance cord. The next one the same, but when I plugged the balance coard in as the last one smoke came up from the board and one of the connecting lanes between the soldering points was burned over.
There were no power on the board when I installed the batteries.
Have I done something wrong or is there a problem with the board?
Later I charged the batteries (Icharger 306B) one at a time, but I was not able to make a balanced charge, because the charger said there were something wrong, when I plugged in the balancing cable.
When they were charged I again tried to make a balanced charge, but with no luck.
Do you think the paraboard have destoyed my balancing cables?
Claus.
There were no power on the board when I installed the batteries.
Have I done something wrong or is there a problem with the board?
Later I charged the batteries (Icharger 306B) one at a time, but I was not able to make a balanced charge, because the charger said there were something wrong, when I plugged in the balancing cable.
When they were charged I again tried to make a balanced charge, but with no luck.
Do you think the paraboard have destoyed my balancing cables?
Claus.