No connection between my DX18/9020 Naza Mv2 GPS

[putte]

Have connected them as per manual. Binded the tx/rx. Been able to update the unit. The orange led flashes as per no signal......

Plz help a newbie.

thx in advance

 

[OneStopRC]

Check your connections, make sure the plugs from your radio are plugged in the right way up..

 

[putte]

Hi and thx for answer.

Triple checked all wires. Am I missing something here. Tested with 2 different TX and RX. No difference. Selected traditional RX in program. Have
updated the unit. Motors beeps during connection. All leds lighten up, then 4 green flash, then continue to flash orange all the time.



Desperate now....

 

[OneStopRC]

Just looking at your picture, I already noticed something wrong. As I said, check your connections are correct!.... If you look at your bottom plugs they are all plugged in the same way, brown on the bottom, red middle and orange on top.

The way they come out of the naza is as follows.

Brown is -
Red is +
Orange is Signal

It would appear the top plug on its own (AUX2) I presume is upside down according to your sticker on top, your X2 plug should be orange on the bottom and brown on top. hope you did not do any damage, and I hope that is all that is out of place.

 

[Benjamin Kenobi]

Agreed. Your Aux2 is wrong. Signal towards the middle with spektrum. No damage done. Just switch it around.

 

[putte]

Good find deanot. But no luck. Took a try with another receiver again, now only with a batt pack and a servo. A orange HK 6ch. Now I can get a servo to react when plugged in. But with the 9020RX
the servo only centers but no reaction to the stick.

 

[OneStopRC]

Stupid question, but you did bind the rx with the tx right? Other then this, I am a Futaba man for this very reason...lol

 

[putte]

Oh yes, several times too.... Futaba, hmmm....

 

[tstrike]

Could you be stuck in failsafe? When you hit your flight mode switch you set up, do all the modes turn blue at the right spot in naza assist?

 

[putte]

Theres no chance at all to get some signals out from the TX. Not even with only a battery pack and a servo. Seems like my TX is DOA.

 

[putte]

UPDATE

Got a tip to plug in both sats. Only tested with one, even though the manual says two required... Must learn to read better. Stupid man! Seems to work with the
servo config now. Lets hope for success in the Naza setup as well....
Thx guys for ur effort!