Need help please!

[kobus vd Bank]

Hi guys. I recently bought a heavy duty quadframe copter that just would not fly. Turns out the copter had aircraft escs in. So I stripped and fitted blheli 30amp escs running tiger 770kv with 12x5 props.
Escs were zerod and calibrated...all hooked up. Linked up with assistant. Did the tx calibration...tested the motors. Btw tx was set to traditional
Ok....so now the fun starts. Tx on....battery plugged in...tx binds with radio...yet the LED keeps blinking orange?
Please help!!!

 

[SleepyC]

OK... slow down.. what flight control, what radio, what kind of set up.. so much info needed!

 

[kobus vd Bank]

Hi Sleepy. Tx mate appreciate. I think I need to restart the whole thing. Remove and re calibrate each esc.
I am running Futaba 12fg and naza V2. I see they reckon midpoint must be 1520 us on speed control etc...so I need to check into it. The flashing I realised was the 3 way swith between manual atti and failsafe....so managed to get that sorted. But still cannot get the motors to activate. It turn in motor setup..and correct direction. But when I push sticks into the corners nothing happens. It's set to intelligent startup

 

[Motopreserve]

The radio calibration in Naza assistant completed successfully? All sticks move to the correct direction when viewed in Naza assistant? When you did the radio calibration, we're all the sub-trims at zero?

 

[eskil23]

...yet the LED keeps blinking orange?

Place it level and start IMU-calibration in the assistant. Let it stay for about 10 min.