NAZA V2 throttle power issues

ZAxis

Member
We have just mounted the new H3 go_pro gimbal on our TBS frame. Using the new Naza V2 has anyone else noticed the extremely long windup speed when motors start? On ours they fire up then there is no increase in power untll the throttle stick goes over 50%, they then wind up to liftoff speed over about 3-4seconds. The worst part I have found is when you are doing a quick decent, if i put the throttle bellow 50% then there is this delay if i start to increase power say to catch the craft as it's coming down, Had a few near misses when the power just wasn't increasing at the rate it was on the sticks.
Anyone Else?
Lec
 

OneStopRC

Dirty Little Hucker
Don't know much about the delay in throttle response, but the 50% throttle before take off is now the normal with DJI Naza systems.
 

Yes the new Normal in Attitude and GPS/Attitude mode, once the copter takes off at 50%+ throttle in AT/GPS mode the throttle control returns to normal and functions normally at under 50% as before.

If you want to take off as before (with full throttle control) switch to manual and you will have full control as before.
Regards - bruce
 

Top