naza problem with gps upgrade firmware

[hpmc]

not sure if anybody has had this problem I have a dji 550 hexa and was working fine on assistant 1.2 I have now got the latest 1.6 assistant and firmware 2.01,
I have done the firmware upgrade and it now shows software 1.6 and FW 2.01, when i try to set it up all i am getting is 3 motors running 1 2 & 4,i am setting it as a hexa V and writing to it every time. i have tried going back to 1.2 and it worked fine. motor idle speed tried at all settings.any help would be Appreciated.
thanks Jeff

 

[michaelcurtisjr]

I had a similar Problem.....

I found that the new slider in the motor mixer section cured the problem I had to increase the motor idle speed.
After that all of my motors would spin up. I also reprogrammed my speed controllers to mid speed in an effort to
get the setting off of high. I suspect the firmware upgrade is causing many existing users grief.....

Hope this helps

MCJ

 

[hpmc]

problem now fixed thank to Alex @ UAV shop.co.uk it seems my rc timer esc's would not work on assistant 1.6 but did on assistant 1.2
rgds Jeff

 

[SamaraMedia]

I tried to upgrade this weekend from 1.2 to 1.6 assistant and ever since I can no longer get a connection between my NAZA and the assistant. The UV LED doesn't light up any more and I do not get the two tone connection on my PC like before. I've tried reinstalling the drivers but have not been successful at this point. It was working all fine and dandy until I tried the update. Any suggestions?