Hello everybody!
I have a problem with NazaM V2.
Few seconds after I start up the motors (3-5s), one of them is spooling up by it's own.
I tried to change the motors and I find out that the problem is not the motor, but the output M3 of Naza. Changing all the motors, Naza output M3 is going by different rules compared with others outputs M1, M2, M4...
I have calibrate all ESC's individualy through RX (end points) and made the same setup for all using programming card (Brake off, Normal start, Governor Off); I have cut the red and black wires from ECS even if it is ESC with linear BEC... I have tried lots of "heard by" solutions but without a positive effect.
I have selected the correct layout (quad X), tested motor directions. I tilt, pan, roll it and all of them are as they should be. All wires are installed correctly. All props are installed correctly, CW and CCW according to each motor spinning direction.
First attempt video:
Trims: A:0; E:0; T:0; R:0
Subtrims: A:-11; E:4; T:0; R:20
Naza Assistant Channel Monitor: A:-1; E:-2; T:-1000; R:0
View this video on YouTube
Second attempt video:
Trims: A:0; E:0; T:0; R:0
Subtrims: A:0; E:0; T:0; R:0
Naza Assistant Channel Monitor: A:-1; E:-1; T:-1000; R:2
View this video on YouTube
Setup:
NazaM V2 + GPS
Turnigy 9X 9Ch Transmitter w/ Module & 8ch Receiver (Mode 1) (v2 Firmware)
Bumblebee - Brushless Motor 930rpm/V
TURNIGY Plush 25amp
Quad X type
Could anybody help me in this situation?
Thank you!
I have a problem with NazaM V2.
Few seconds after I start up the motors (3-5s), one of them is spooling up by it's own.
I tried to change the motors and I find out that the problem is not the motor, but the output M3 of Naza. Changing all the motors, Naza output M3 is going by different rules compared with others outputs M1, M2, M4...
I have calibrate all ESC's individualy through RX (end points) and made the same setup for all using programming card (Brake off, Normal start, Governor Off); I have cut the red and black wires from ECS even if it is ESC with linear BEC... I have tried lots of "heard by" solutions but without a positive effect.
I have selected the correct layout (quad X), tested motor directions. I tilt, pan, roll it and all of them are as they should be. All wires are installed correctly. All props are installed correctly, CW and CCW according to each motor spinning direction.
First attempt video:
Trims: A:0; E:0; T:0; R:0
Subtrims: A:-11; E:4; T:0; R:20
Naza Assistant Channel Monitor: A:-1; E:-2; T:-1000; R:0
View this video on YouTube
Second attempt video:
Trims: A:0; E:0; T:0; R:0
Subtrims: A:0; E:0; T:0; R:0
Naza Assistant Channel Monitor: A:-1; E:-1; T:-1000; R:2
View this video on YouTube
Setup:
NazaM V2 + GPS
Turnigy 9X 9Ch Transmitter w/ Module & 8ch Receiver (Mode 1) (v2 Firmware)
Bumblebee - Brushless Motor 930rpm/V
TURNIGY Plush 25amp
Quad X type
Could anybody help me in this situation?
Thank you!