Harrison Silber
New Member
Hello,
I am building a quadcopter using DJI's NAZA-M lite flight controller and e310 tuned propulsion system. I am using a Spektrum DX6 with an AR6210 for my transmitter/receiver pair. I am supplying power to the flight controller and receiver through my ESCs and a 3 cell Lipo battery. I have set up my DX6 for the NAZA. My DX6 is also bound to the AR6210. When I plug in the NAZA to my mac, I get an error that reads CFG-ERR. I know there are many other posts about this, but I cannot seem to find the answer.
Also, I can calibrate the sticks on the DX6 but on the NAZA program the sliders are grey and they do not respond to my DX6. Both the blue light and green light are lit on the bottom right of the NAZA program.
I am building a quadcopter using DJI's NAZA-M lite flight controller and e310 tuned propulsion system. I am using a Spektrum DX6 with an AR6210 for my transmitter/receiver pair. I am supplying power to the flight controller and receiver through my ESCs and a 3 cell Lipo battery. I have set up my DX6 for the NAZA. My DX6 is also bound to the AR6210. When I plug in the NAZA to my mac, I get an error that reads CFG-ERR. I know there are many other posts about this, but I cannot seem to find the answer.
Also, I can calibrate the sticks on the DX6 but on the NAZA program the sliders are grey and they do not respond to my DX6. Both the blue light and green light are lit on the bottom right of the NAZA program.
