alx
Member
Hi there! I 'm having problem to understand how to manually tilt my Arris cm2000 gimbal . I m using a spektrum dx7s -Ar8000 and a naza-m controller with Gps. I have connected the Arris cm2000 (pitch and ground) wires to the F2 port of naza ,roll wire is not connected . Gimbal is stable and work fine but
when i move the throttle stick over 10% my gimbal starts moving 90 degrees and i can t bring it back to central position (this is what i don t want) unless i move again the throttle stick down. i have set the X1 port of naza to the Aux 1 of my spektrum so i m able to control pitch by knob.
i would like the gimbal to be in a horizontal position when i lift of and making adjustments only from my knob 0 -45-90 degrees ?
i m guessing that this has to do with the pitch control which is in the same stick with throttle.
i didn't make any adjustments to the arris sofware . {Arris cm2000 red board/ com5 - ver.1.3}
any help would be useful...
thanks!
when i move the throttle stick over 10% my gimbal starts moving 90 degrees and i can t bring it back to central position (this is what i don t want) unless i move again the throttle stick down. i have set the X1 port of naza to the Aux 1 of my spektrum so i m able to control pitch by knob.
i would like the gimbal to be in a horizontal position when i lift of and making adjustments only from my knob 0 -45-90 degrees ?
i m guessing that this has to do with the pitch control which is in the same stick with throttle.
i didn't make any adjustments to the arris sofware . {Arris cm2000 red board/ com5 - ver.1.3}
any help would be useful...
thanks!