Naza gps

C

Chalagi

Member
I connect my naza gps to the laptop and open assist. then load newest version firmware and software , Recalibrate everything but my GPS calibration does not show up in the program. Any suggestions?
 

kloner

kloner

Aerial DP
gps cali is done on the ground/table..... flip man'atti'gps switch back and forth a few times till the light comes on solid,,,,, rotate it 360 then green light, flip it nose up or down and rotate it 360 keeping it nose up or down
 

Bison52

Bison52

Member
And hope the neighbors don't call the cops and report a drunk guy whirling around in the front yard.
 

C

Chalagi

Member
Another question I don't have cables for the gear, aux2, x1 and x2 channels. I think that's why I can't finish setting up my other switches correct. And if that's the case where can i get the cables and what do I ask fro?
 


C

Chalagi

Member
Ok guys I went to my LHS and got 2 more cables. I connected my gear channel to my X! and my Aux2 channel to the X2. So right now I have the 3 way position switch that has GPS/ATT/Man and I have the Aux2 switch for the IOC (off and home lock) at lest that's what it shows in the naza assist. and I hope it works like it shows in the assist. The only thing that I don't have right now is RTH and failsafe. In the naza assist it can't figure out what the gear channel does.
 

You must log in or register to reply here.
Top