MultiWii / NAZE / SP Racing F3 Multiwii Crius V2.5 Flashing Blue Light

[mrsand]

Friends

A short history

purchased a quad arf with crius se v 2.5 FCB

assembled and tried different arduino tools ...finally got he board to upload the conf.h file with arduino v 1.0 using the Duemilinove with ATmega 328p board in the tools menu with no errors

now when I try to start up the quad for bench testing the board flashes a blinking blue light and a steady green...board won't arm pushing throttle at down position and right

all connections appear correct into the board

Can anyone advise what to do to get the board to arm

 

[JLawrence]

I know this may sound dumb, but did you make sure to uncomment everything you needed to in the config.h location of the code? Also, before you uploaded the new code did you do an eeprom clear to wipe the board?

 

[SoCal Blur]

Also, make sure in your TX that the throttle's lowest position is not above 1000. If its set too high, the motors won't arm.