Looking at using a Ronin-M on my heavylift, any interference issues ?

[UAValien]

Hi

Im looking at using a Ronin-M on my heavy lift build, but my question is will the Ronin-M gimbal remote interfere with my remote on he Skyjib X4 ?. Im running a graupner MZ-24 to control the skyjib X4, if i put a ronin-M on it will the controller for the ronin-m cause communication problems with the graupner to skyjib ?.
As both run on 2.4ghz ?.

any one using 2.4ghz to control both gimbal and drone ?.

thanks

Mark

 

[SleepyC]

No issues. This is how all 2 man systems are done.

 

[UAValien]

great, thanks for the reply.

 

[Area21]

I fly a SkyJib x4 Ti QR as a 2 person set up. Both transmitters are Futaba 2.4 ghz.

 

[UAValien]

That's great thanks for the reply's, give me great confidence now.

 

[violetwolf]

I even use two tx's in the same case. With my Taranis I use the built in module to control the craft and the external module for the gimbal.. Both 2.4 and the antennas an inch or two apart. I did very extensive range and reception testing before flying, and have flown the rig for all of last season without any hiccups.

You might say its the ultimate test of modern channel switching radios lol.