KK Flight Controller KK esc calibrated but keep beeping

C

claustro

New Member
Hi all ,
I have an old kk board.
I calibrated every single esc , and then I attempted to calibrate all esc on the board .
But the result are:
at min yaw pot:
one motor start regularly
two motors, don't start and escs keep beeping at high frequency.
at max yaw pot
three motor don't start and esc keep beeping at low frequency.

I tried to lower the thrust at min , expand the thrust limit to maximum 125-125 with no luck.
Is there anyone who can help me?
 

S

Stacky

Member
When the beeping is happening does it go away if you lower your throttle trim.
When doing the esc calibration its important to check that you have set all your trims to zero.
I think you need to set your tuning pots to their central position, set your radio trims to zero and then do the esc calibration.
Once thats done then you can go back to doing the tuning of the fc via the pots.
 


S

Stacky

Member
What esc's are you using?

Here is a simple video explaining how to set the throttle points, before you do this make sure that you set the trims to zero again.
Check to see if you are doing the esc throttle points the same way as the video. Let us know if this is what you are doing.
Make sure you have your esc plugged in to your throttle channel, usually channel 3.

http://www.youtube.com/watch?v=AbWpLb87Q6U

claustro said:
Thank you very much for your answer, I tried lowering the trim but the esc keep beeping in the same way .
Have you any idea?

Andrea
Click to expand...
 

You must log in or register to reply here.
Top