RyanMcCrae
Member
Hi Guys,
I was just taking my 3 axis gimbal apart to replace some parts. I accedently pulled the motor leads off, when i was pulling one of the carbon tubes out of the clamps.
Now I need to disassemble the motor and take the stator off to solder the leads back on, its a 5108-120t, does any one have any tips?
I had this happened once before where I suspect a lead was broken, But i didn't have any luck removing the stator. Just couldn't do it.
I was just taking my 3 axis gimbal apart to replace some parts. I accedently pulled the motor leads off, when i was pulling one of the carbon tubes out of the clamps.
Now I need to disassemble the motor and take the stator off to solder the leads back on, its a 5108-120t, does any one have any tips?
I had this happened once before where I suspect a lead was broken, But i didn't have any luck removing the stator. Just couldn't do it.
Last edited by a moderator:
