My HFP and GPS board arrived this week, and I've spent the weekend wiring everything up and trying to setup the HFP.
I cannot get the HFP setup client to connect, and I cannot get the board to arm.
What I can do:
- I can connect to both the HFP and GPS board in the firmware Update Client, and can update to both 4.8 and 4.8 uBlox (I have the new #DR uBlox GPS module too). I have currently updated both boards to 4.8 uBlox.
- I can power on the board and RX using the battery. I am using S5 batteries, plus a DPCAV voltage regulator and a power filter to deliver 9v to the HFP and RX (I have a FrSky x8r, which is bound to my Taranis, and lights up green with a successful connection). The HFP powers up, then flashes green and beeps constantly.
- I cannot arm the HFP though, it just keeps beeping and flashing green.
What I can't do:
- Connect to the setup client to check that the TX inputs are all correct, coming through the right channels, etc.
- I get the HFP flashing purple just fine, when the program switch is in Position 2 (closed to the edge of the board). I press connect in the setup client, and it asks me to switch to Position 1. When I do this, it searches again, and then comes up with an error that no board can be found.
- When I change with switch position, the board restarts, but then flashes green or red depending on which position I switch the GPS board programming switch to.
- I have tried multiple USB cables, all with the same result.
I'm getting pretty frustrated with it! Does anyone have any suggestions?
I cannot get the HFP setup client to connect, and I cannot get the board to arm.
What I can do:
- I can connect to both the HFP and GPS board in the firmware Update Client, and can update to both 4.8 and 4.8 uBlox (I have the new #DR uBlox GPS module too). I have currently updated both boards to 4.8 uBlox.
- I can power on the board and RX using the battery. I am using S5 batteries, plus a DPCAV voltage regulator and a power filter to deliver 9v to the HFP and RX (I have a FrSky x8r, which is bound to my Taranis, and lights up green with a successful connection). The HFP powers up, then flashes green and beeps constantly.
- I cannot arm the HFP though, it just keeps beeping and flashing green.
What I can't do:
- Connect to the setup client to check that the TX inputs are all correct, coming through the right channels, etc.
- I get the HFP flashing purple just fine, when the program switch is in Position 2 (closed to the edge of the board). I press connect in the setup client, and it asks me to switch to Position 1. When I do this, it searches again, and then comes up with an error that no board can be found.
- When I change with switch position, the board restarts, but then flashes green or red depending on which position I switch the GPS board programming switch to.
- I have tried multiple USB cables, all with the same result.
I'm getting pretty frustrated with it! Does anyone have any suggestions?