hi Can I use Heli version futaba for xaircraft or it has to be plane version

[steph280]

So basically you are giving up Normal mode and substitute it with failsafe on the three position switch?

There's talk about using PMIX to allow a separate failsafe switch. I haven't experimented with that yet since the 14MZ has "flight modes" which allows one switch to override the other switch, achieving the same effect without any mixing.

 

[paktazh]

no I got the 3 switch set for GPS A And M but I mix another Switch D as master to take it to fail safe the way u r saying is to pick 3 way switch for all modes it is impossible if i am not mistaking

 

[Highalander]

So basically you are giving up Normal mode and substitute it with failsafe on the three position switch?

There's talk about using PMIX to allow a separate failsafe switch. I haven't experimented with that yet since the 14MZ has "flight modes" which allows one switch to override the other switch, achieving the same effect without any mixing.

Yes Steve as I see no need to use "normal" position. But I could change them back after setting failsafe (DSX9).
Paktazh, I set the trims/end points for GPS , Attitude , Failsafe and then bind my Rx Tx as per instructions for failsafe. I could then then change the trims/end points back to GPs , Attitude , Manual if I wanted. The main reason in setting Failsafe is in case you lose the signal between Tx -Rx. So now I can go to Failsafe by Switch or turning off my TX