Steadimoves
Member
Hi Guys,
Anyone experience this or have any ideas on what im missing??
I had my f/c mk 2.1 on my gimbal and was using it only for the camera control separate to my cinestar 8, it had the firmware from quadrocopter for the gimbal installed-all working perfectly.
Now i need that board back on my cinestar 6 for a while, I've reinstalled 88n firmware on the board and when i plug into kopter tool i get all green lights-everything is ok. I have a graupner mx20-all the controls are configured properly-i can see the right values change in kopter tools for the right inputs.
As soon as i calibrate the board it beeps 3 times like normal then nothing-kopter tools page seems to freeze-the inputs from the mx have no effect and i cant start the kopter.
I could be missing something simple but i cant seem to find it!!
Any advice would be greatly appreciated.
Best regards
Matt
Anyone experience this or have any ideas on what im missing??
I had my f/c mk 2.1 on my gimbal and was using it only for the camera control separate to my cinestar 8, it had the firmware from quadrocopter for the gimbal installed-all working perfectly.
Now i need that board back on my cinestar 6 for a while, I've reinstalled 88n firmware on the board and when i plug into kopter tool i get all green lights-everything is ok. I have a graupner mx20-all the controls are configured properly-i can see the right values change in kopter tools for the right inputs.
As soon as i calibrate the board it beeps 3 times like normal then nothing-kopter tools page seems to freeze-the inputs from the mx have no effect and i cant start the kopter.
I could be missing something simple but i cant seem to find it!!
Any advice would be greatly appreciated.
Best regards
Matt
Last edited by a moderator: