So I have been following the dji f550 build on youtube and I have everything built and now binding the copter to the radio. So I hooked the battery up and turned on the radio and hit the bind button on the receiver, and I still get the quick flashing yellow. After a few minutes of turning the radio off and on and unhooking the battery I finally get it bound. Then when I am in the naza program to set everything up it loses signal again. Now I am unable to get it to work again.
Also on a side note when it was working for a few minutes, my switches were only going from atti to failsafe. They wouldn't go to anything else. Don't know if this was bc it wasn't set up properly or not. I just used the s-bus.
When I hook it up to the computer the LED turns green but I am not able to do anything with my radio. So for some reason my radio is not binding with the receiver? I have check to make sure the connection is good and everything seems fine. I get a green light on the receiver when the radio is on and red when i turn the radio off. So it seems like they are connected, but I still get the quick flashing yellow on the LED. I keep trying the button on the receiver and it turns red for a second then back to green but the fast flashing yellow still remains. I had it working at one point but now I have no idea how to get it working again. :/ Any ideas would be greatly appreciated. Thanks again.
I have tried everything and I am lost on what to do at this point. I attached an image of the error code I am receiving when hooked up to the naza software.
Does anyone have any suggestions?View attachment 14073
Also on a side note when it was working for a few minutes, my switches were only going from atti to failsafe. They wouldn't go to anything else. Don't know if this was bc it wasn't set up properly or not. I just used the s-bus.
When I hook it up to the computer the LED turns green but I am not able to do anything with my radio. So for some reason my radio is not binding with the receiver? I have check to make sure the connection is good and everything seems fine. I get a green light on the receiver when the radio is on and red when i turn the radio off. So it seems like they are connected, but I still get the quick flashing yellow on the LED. I keep trying the button on the receiver and it turns red for a second then back to green but the fast flashing yellow still remains. I had it working at one point but now I have no idea how to get it working again. :/ Any ideas would be greatly appreciated. Thanks again.
I have tried everything and I am lost on what to do at this point. I attached an image of the error code I am receiving when hooked up to the naza software.
Does anyone have any suggestions?View attachment 14073
