New to the sport. Trying to program my Futaba J10 to DJI F550 with Naza M V2 controller. Using traditional servo set up, not S bus. Want to know how to set up failsafe in the NAZA software. Currently have the following configuration. .Receiver channel 5 to (x1) ( VR), Channel 6 to (U) to Switch E a 3 way switch for mode change and Channel 7 to (X2) 3 way Switch C (IOC)..I have all switches working properly and now want to program a separate switch to Failsafe on the NAZA so I can go to failsafe in any of the three modes programmed on
Switch E... How can I do this??? I think it takes some P-Mix and a new switch assignment but have not been able to figure it out...Once I get a switch assigned, how do I use subtrim and endpoint to get into the middle position of failsafe on the mode screen? When I call DJI they will not help me because Futaba is not their product even though so far I have spent about $1500 on DJI product to get this thing set up with camera and Zenmuse set up..
Thanks
Fred
Switch E... How can I do this??? I think it takes some P-Mix and a new switch assignment but have not been able to figure it out...Once I get a switch assigned, how do I use subtrim and endpoint to get into the middle position of failsafe on the mode screen? When I call DJI they will not help me because Futaba is not their product even though so far I have spent about $1500 on DJI product to get this thing set up with camera and Zenmuse set up..
Thanks
Fred