FrSky Taranis X9D setup flight mode for both RC drone and GIMBAL control

pozzatelloluca

New Member
Hello,
I'm new to this forum. :):D

I need help to configure my RC controller for both flight and gimbal control.
I have to control a drone with the Wookong-M flight installed and controlled by the radio FrSky X9D PLUS TARANIS and receiver X8R in MODE16.
As gimbal controller I have bought the ALEXMOS ARMBGC 32bit 3-axis.

My idea is to configure a switch for 2 "flight modes" in order to control the drone until its final position and next keep this switch for holding GPS position and height in flight and start controlling only the gimbal.

Nobody have done the same things or have an idea on how to do it?

Thanks in advance at all the friends that will read this... o_O
 

Ti@goo

Member
I`ve read some months ago a guy did exactly in the Rcgroups forum. I think it was in a thread about de Tarot680pro..
 



Top