Antwnis
Member
F550 with WKM ... No spin motors
Hello to all,
My name Antonis from Athens /Greece ,
Build a 550 with WKM ... Step by step install the program DJI WKM all ok ...
Now I have a problem, after from install the program and fix all parameter for my f550 (x/z for gps /calibrator tx / failure safe mode gps ...) don't spin the motors !!!!
I saw many others parameters from my tx (futaba 10CG ) and from my F550/ WKM / and program .
I Test esc's alone with motors and it is ok ...!!! I put Esc (without D Bus) on receiver and all Esc and motors
After all the above I understand that the D Bus *not send commands to the receiver ...
Is there a secret, any tips, something that did not, beyond the manioual and program?
Thanks
Good wishes To all.
Antonis
Hello to all,
My name Antonis from Athens /Greece ,
Build a 550 with WKM ... Step by step install the program DJI WKM all ok ...
Now I have a problem, after from install the program and fix all parameter for my f550 (x/z for gps /calibrator tx / failure safe mode gps ...) don't spin the motors !!!!
I saw many others parameters from my tx (futaba 10CG ) and from my F550/ WKM / and program .
I Test esc's alone with motors and it is ok ...!!! I put Esc (without D Bus) on receiver and all Esc and motors
After all the above I understand that the D Bus *not send commands to the receiver ...
Is there a secret, any tips, something that did not, beyond the manioual and program?
Thanks
Good wishes To all.
Antonis