XAircraft EZUHF connection with SuperX

traxx2003

traxx2003

Member
Hello everyone, I was wondering if someone could help me figuring out how to connect the SuperX with an EZUHF receiver. I know that the SuperX with the I/O unit V2 is now SBUS compatible. The EZUHF receiver also supports SBUS thru channel 1, as long as you set CH 1 to Muxed. But when I connect and power the system, all Im getting is a red flashing light from the SuperX, indicating that the RC connection is not present. Can someone explain how I should connect the SUPERX to the EZUHF system?
Thank you!!
 



traxx2003

traxx2003

Member
Sure did, i had to connect all servo wires. For some reason, even dough both of them are SBus compatible, they will not work with SBus together. I believe is because SuperX uses PWM signal and EZUHF uses PPM. But don't quote me on it. But is you use one servo wire per servo, it works just fine.
 

You must log in or register to reply here.
Top