AboveAllAP
Member
Hi All
I am in the processes of building my first Multi rotor and I am wondering if anyone has or know reasons not to use terminal blocks on the frame to connect the ESC controllers into. My thoughts are rather than having to un-solder and re solder when replacements ESC are required I could solder a terminal block onto the frame. I would use threadlock to make sure the terminal screws did not loosen. My other thoughts against doing this was voltage drop across the join and of course a little extra weight.
I am in the processes of building my first Multi rotor and I am wondering if anyone has or know reasons not to use terminal blocks on the frame to connect the ESC controllers into. My thoughts are rather than having to un-solder and re solder when replacements ESC are required I could solder a terminal block onto the frame. I would use threadlock to make sure the terminal screws did not loosen. My other thoughts against doing this was voltage drop across the join and of course a little extra weight.