Need Help! Eachine ET600 power solution

[HexaTiger]

So I recently purchased the aforementioned video transmitter. The included power plug is a 3s balance plug, but only has two wires leading to the board. I'm assuming they come from the first and last pin to draw the full power of the battery.

I purchased a 2s battery to power my FPV gear and was wondering where I could purchase female 2s connectors to replace the 3s one included in the box.


Sent from my iPhone using Tapatalk

 

[theGreenOrange]

Like these?

https://www.amazon.com/gp/aw/d/B00WO3LMPS

Or is it a little red plug?

 

[HexaTiger]

They are JST-XH, I need the female connectors.


Sent from my iPhone using Tapatalk

 

[HexaTiger]

Correction: the housing is female, I think it has the male pins though.


Sent from my iPhone using Tapatalk

 

[theGreenOrange]

I think the ones I linked have 10 each of male and female connectors included. Do they look different than what you need?

 

[HexaTiger]

I don't think so. They are your standard jst-xh balance connectors. I have a 2s Turnigy battery I'm using on my FPV gear


Sent from my iPhone using Tapatalk

 

[theGreenOrange]

I don't think so. They are your standard jst-xh balance connectors. I have a 2s Turnigy battery I'm using on my FPV gear


Sent from my iPhone using Tapatalk

Ok, sorry I thought you were saying the vtx somehow used the balance connector to draw 1S voltage.